CONTROLLER
  
                                                      1
 
The CAL24A Series is a stand alone microprocessor based controller, 
providing 0-10V DC control.  This series controls a variety of two-
pipe and four-pipe air-handling units, heat pumps unitary equipment 
and various heating and cooling applications controlled by valve, 
damper and fan systems.
 
 
Supply Voltage:                                    24 VAC +/- 15%, 50-60 Hz 
Outputs:                                               0-10 VDC 
Power Consumption: 
                          24 VAC, 2VA 
Deadband:                                           -3бн+3K 
Setpoint Range:                                   0бн30 
o
Shipping Weight: 
                                105 g
 
CAL24A1                         Single output
 
0-10 VDC
 
CAL24A2                         Dual output
 
0-10 VDC 
The P74JA Series differential pressure controller is commonly used 
on water systems to control a pressure differential between supply 
and return lines. The controller's SPDT floating action contacts  
position a modulating valve operated by a motor-driven actuator. In a 
typical application the valve is located in a bypass line around the 
system pump. When the system pressure differential increases 
above the controller's set point, the valve opens further. More water 
is diverted through the bypass valve, resulting in a reduction in  
system pressure differential. A reduction in the pressure differential 
causes the valve to begin closing and results in an increase in  
system pressure differential.
 
 
Range:                                                 55бн414 kPa (8бн60 PSI) 
Operating Pressure Differential:           14 kPa (2 PSI), fixed 
Max. Bellows Overrun Pressure:         1241 kPa (180 PSIG) 
Max. Allowable Differential in  
Pressure Between Bellows:                 830 kPa (120 PSI) 
Electrical Ratings:                                1 Ampere, 24 V, 50 / 60 Hz 
Switch Action:                                      SPDT, totally enclosed  
                                                             non-snap acting switch 
Ambient Operating Temperature:        -1бн60 
o
Mounting:                                             Mounts to flat surface 
Wire Terminals:                                   Color coded screw terminal 
Shipping Weight: 
                                1.1 kg (2.4 lb) 
P74JA-3
               
SPDT, totally enclosed non-snap acting switch
 
The CAL24T Series microprocessor based controller provides com-
binations of on/off and 3-wire floating (incremental) control.  This se-
ries controls a variety of two pipe air handling units, heat pumps, uni-
tary  
equipment and various cooling and heating applications.
 
 
Supply Voltage:
   
           
24 VAC +/- 15%, 50-60 Hz 
Outputs:
        
           
24 VAC, 12 VA 
Power Consumption:
           
24 VAC, 1 VA 
Setpoint Range:
   
           
0бн30 
o
Ambient Limitations:
            
0бн50 
o
C, 90% RH
 
Shipping Weight: 
  
 
           
100 g 
CAL24T                           Single output
 
24VAC, 12VA