DAMPER ACTUATOR 08, 16, 24 & 32
4
General
The 08, 16, 24 & 32 Series damper
actuators are designed for drive medium to
large size damper with 2 or 3-wire
floating, on/off and proportional voltage /
current control to operate dampers in air
control system.
Key Features
A key feature of the design is the special
spindle adapter which also incorporates an-
gle-of-rotation limiting and position
indication. Auxiliary switches and
Potentiometer are available for separate
order, however 0 ¨C 10 VDC position signal
feature is built-in for proportional control
models. For ease of installation, the
actuator mounts directly onto the damper
shaft in minutes
?
2 or 3-point control, 0-10 VDC control
?
Load independent running time
?
Paralleling of up to 20 actuators
possible
?
Screw terminal connections
?
Universal adapter for: Round spindles
from 10 to 20 mm dia
?
Square spindles 10¡16 mm
?
Choice of rotation
?
Angle-of-rotation limiting
?
Manual control by pushbutton
?
Power saving at end stops
?
Customizing available
The specification above are normal and conform to generally
acceptable industry standard. Cyrus is not responsible for
damages resulting from misapplication or misuse of its products.
8¡32 Nm Actuators for On/Off,
2 or 3-Wire Floating or Proportional
Control of Damper
